These manuals have been produced by fiamma and are provided as a guide to the installation of fiamma awnings.
Caravan awning fitting instructions.
Awning rail is the most secure fixing method to use if you are fitting a porch or drive away awning and is the only suitable option if you want to fit a traditional caravan awning or roll out bag awning.
Finally refit the support arms and refit the awning strap.
2 1 for vinyl awnings place screw through awning rail polyrod and canopy approximately 1 in from the end of.
An f clamp holding the vinyl can help to get a better purchase on the material and make it easier to slide it on.
Re fit the screws that secure the material in place.
The roof poles fit into bracket pads that either slide or clip into position on the awning bead.
Our expert team at jillaroo caravan awnings accessories also provides full fitting for any products purchased.
Don t lock the pads in place until the roof poles are correctly positioned.
Fit the front centre vertical pole through the roof canvas and leave it at an angle to support the roof.
Your awning may vary from the information provided.
Five steps to porch awning heaven.
As with full size awnings read the instructions and identify each part of the frame colour coding them to avoid any guesswork on site.
Caravan awning installation services in clontarf if you re a local to brisbane or travelling through the area stop by our clontarf workshop to get your new caravan products right away.
To finish with fit the draught strip and wheel arch cover as well.
Again with your helper slide the stitched in cord of the awning material into the rope track on the caravan.
The same is required when fitting the top brackets although 100mm x 100mm x 3mm aluminium plate painted vilotone white fixed into place with rivets and silicone.
Slide the canvas into the awning channel and position it as accurately as you can.
Secure the canopy fabric or alumaguard using one 6 x 3 8 hex head screw at both sides of the awning.
Securing the awning fabric.
Slide the vinyl up to the marks you made on the roll earlier.
Re fitting the torsion assembly making sure that the grooves line up.
Now pull out the awning to make sure that it operates properly.
For diy fitting of awning rail make sure to use a suitable sealant to avoid leaks in the van wall.
The number of poles is dictated by the awning s size.
